Almost There

While it may not entirely look like it, the 850T project is finally ready to be started for the first time.  The fuel petcocks have been attached to the tank, and the carbs are on with new lines waiting for the tank.  After the headers are attached, it can be started.  Should be tomorrow.

Completed so far (~60-70%) are:

• frame mounted to engine, along with center and side stands
• U-joint installed, bearings replaced and greased and swing arm mounted
• rear drive attached, with shocks
• headstock bearings greased and triple trees attached
• forks serviced and attached
• all electrical (new harness) laid out and connected, including coils, rec/reg, fuse box, relays